Point to Multipoint 2K-CPE Configuration

Introduction

This quick guide shows how to set up Gigawave 2K-CPE wireless bridges in a Point-to-MultiPoint setup. Like regular pairing, you set one unit as the Host (H) and the others as Clients (C).

TABLE OF CONTENTS

• What is Point-to-Multipoint?

• Step-by-Step Setup

• What Does It Do?

What is Point-to-Multipoint?

Point-to-MultiPoint means one Host connects to multiple Clients wirelessly. This works great where buildings are in line of sight, like connecting barns to a main house on a farm.

No cables needed. Just put the Host at the main house and the Clients at each barn.

Step-by-Step Setup

1. Set Up the Host (H) Unit

• Open a web browser and go to: 192.168.1.150

• Log in with the password: gigawave

• Set the WiFi name (SSID) to: GigaAP

• Set the WiFi password to: gigawave

• Save and apply the settings

2. Set Up the Client (C) Units

For each Client unit:

• Open the web interface

• Go to Repeater Settings

• Make sure P2P Mode is OFF

• Check Lock to AP

• Click Scan and find GigaAP

• Select GigaAP and enter the password: gigawave

• Click Apply

• Repeat for all Client units

What Does It Do?

• Clients connect to GigaAP automatically

• Host allows multiple Clients to connect at once

• Creates a simple, wireless network between all units